RKC Wood Care Pros is the fence contractor for Anderson County's hub — wood and chain link built to stand the open Garnett wind, and then sealed in-house so it doesn't gray out and fail early the way an unstained fence does. Posts set 36 inches in poured concrete, finish built into the plan. Installation, repair, and staining from one crew. 400+ fences since 2021. Free estimate.
THE GARNETT FINISH CLOCK
The most common reason a Garnett wood fence dies young isn't the build — it's that it never got a proper finish, and the open wind and sun did the rest. So we start where most contractors don't: with the clock. Here's when a fence needs sealing, when a neglected one can still be saved, and when the finish stops mattering because it's too late.
AT INSTALL
New wood needs to release its mill moisture before the first coat — usually a few weeks to a couple of months. We schedule the seal for when the boards are ready, not before, so the stain penetrates instead of sitting on wet grain.
WEEKS 4–8
This is the coat that matters most and the one most Garnett fences never get. A semi-transparent penetrating stain seals the grain against the wind-driven sun and rain before it ever grays. Skip it and the clock on early failure starts here.
EVERY 2–3 YEARS
On the exposed Anderson County lots the wind and sun weather a finish faster than a sheltered suburban backyard. A recoat every couple of years keeps the seal intact — cheap insurance against the rot and graying that follow a worn-out finish.
STILL SAVABLE
If the wood's silvered but still sound, it's not too late. We wash and sand it back, then seal it — bringing a neglected fence back to life for a fraction of a replacement, as long as the posts and boards haven't gone soft.
PAST SAVING
Once the boards are punky and the posts rot at the base, staining won't bring it back — that's the endpoint of the years the fence went unsealed. Here the honest call is a rebuild, done right and sealed from the start this time.
NO CLOCK
If you don't want a stain schedule at all, galvanized chain link and vinyl carry a factory finish and never need sealing — the maintenance-free route for a boundary or a low-upkeep yard on a windy lot.
Landmarks near the Garnett lots we fence: Lake Garnett and its racing history, the Anderson County Courthouse on the square, and the Cedar Valley Reservoir — off US-59, US-169, and K-31. Our crews run the US-169 corridor through Anderson County, so wherever your lot sits in town, you're on the route.
Garnett and the towns next door: the same crew fences the Franklin and Anderson County towns around it — Ottawa and Osawatomie — and it all runs out of our Kansas City metro fence shop in Olathe.
WHY GARNETT HOMEOWNERS HIRE US
In Garnett the build is only half the job — the finish is the other half, and it's the half most fences here never get. A crew that installs and walks away leaves the fence to gray out in the wind. Here's what the locals we build for actually weigh.
We don't hand you a raw fence and wish you luck. Staining is in-house, timed to when the wood is ready, and built into the plan from the start — because a sealed fence on an exposed Garnett lot lasts twice as long as an unsealed one.
Wide-open Anderson County lots give the wind a long run at a fence. We set posts a true 36 inches in poured concrete, brace the exposed runs with 6x6 posts and tighter spacing, and use airflow-friendly panels where the wind is worst.
Got a grayed-out fence? We'll tell you straight whether a wash-and-seal brings it back or whether the wood's too far gone for anything but a rebuild — no upsell to replace something a good stain would fix, no false promise on one that's finished.
Owner-run since 2021, and the crew that builds it is the one that returns to seal and recoat it on schedule. There's no window where the wood sits raw waiting on a separate outfit — which is precisely where the town's failed fences went wrong.
GARNETT CONDITIONS
Wind and finish — those are the two forces that write the lifespan of a fence out here, and they work together. Build for the wind and seal against the weather, and a Garnett fence lasts for decades. Miss either and it doesn't.
Garnett's flat, exposed lots take the full brunt of wind-driven sun and rain, and a raw wood fence has nothing protecting the grain. It silvers, dries, and cracks, and once water's getting into open wood the rot follows. The fix is cheap and the payoff is huge: seal it early and recoat it every couple of years, and the same fence lasts twice as long. That's why we build the finish into the job instead of leaving it to a separate call that never happens.
Wind damage is the town's other main fence problem, and it's a build question, not a finish one. On the exposed runs we set 6x6 posts, tighten the spacing, fasten with ring-shank nails so boards don't work loose, and use shadowbox or spaced pickets that let a gust pass instead of catching a solid wall — all over a 36-inch poured footing. Where you just want a boundary, chain link and farm-style wire skip the wind load entirely.
Most of Garnett is flat, wide-open ground with a focus on functional backyard space, which keeps the install straightforward and the price honest — no bluff slopes or rock to fight. That means the money and attention go where they actually matter here: the depth of the footing, the wind bracing, and the finish. We read the lot before quoting, but on most Garnett properties the build is clean and the difference-maker is what happens after the posts are set.
FENCE AND GATE SERVICES IN GARNETT
RKC installs and repairs every type of fence — wood, vinyl, chain link, ornamental iron, aluminum, and commercial security — plus custom gates and in-house staining. Open any card for its Kansas City detail page — options, specs, price bands. It all reaches Garnett on one crew, dug to full depth, and that same crew is the one that seals it after.
The step that decides whether a Garnett wood fence lasts — semi-transparent penetrating stain, applied by the same crew that built the fence, sealing the grain before the sun and wind gray it out and start the rot.
Service details
6-foot cedar and treated-pine privacy, the traditional Garnett build — hung on galvanized ring-shank nails, set on 36-inch posts, and sealed on schedule so it doesn't go the way of the town's unstained older fences.
Service details
Galvanized chain link and farm-style wire — the utilitarian Garnett workhorse for property security and defining a large boundary, with no finish to maintain and nothing the wind can catch.
Service details
Solid 6-foot privacy where you want the backyard closed off — built with the wind bracing the open Anderson County lots demand, and sealed in-house so the finish holds against the exposure.
Service details
The no-maintenance answer for a homeowner tired of restaining — vinyl never grays, never needs sealing, and holds a clean line through the wind and weather with nothing to keep up.
Service details
Wind-racked section resetting and reviving a grayed-out unstained fence are Garnett's two most common calls — we re-set failed posts to 36 inches and, where the wood's still sound, sand and seal it back to life.
Service details
Walk gates and wide farm-style drive gates on welded frames with diagonal bracing — hung to swing true and latch clean on the flat, wide-open lots, and sealed to match the fence they hang in.
Service details
Powder-coated steel picket for a formal front line near the courthouse square — a low-maintenance, long-lasting look with a factory finish that shrugs off the sun and wind without a stain schedule.
Service detailsAlso serving Garnett across the metro: we install aluminum, pool, and commercial security fencing, plus fencing for managed properties. Ask when you book your estimate.
THE WORK WE BRING TO GARNETT
These are real RKC jobs — our crews, our materials, dug deep and sealed in-house, the work we run down US-169 to Garnett. Sealed cedar privacy, dog-ear wood, chain link, stained finishes — the builds Garnett asks for most, shown with the coat that keeps them standing.
GARNETT ESTIMATES · WHAT SHAPES THE NUMBER
A 6-foot cedar or treated-pine privacy fence in Garnett runs about $24 to $34 per linear foot installed, depending on material. Galvanized chain link and farm-style wire for a boundary run well under that, priced by the length of the perimeter. Staining a new fence is a separate line — and dollar for dollar the best protection you can buy for the whole investment on these exposed lots. Vinyl costs more up front and never needs sealing. The footing doesn't change: 36 inches deep in poured concrete. The quote comes free and broken out by line, so the build and the finish each read as their own number rather than a single lump.
Posts, concrete, hardware, the staining, cleanup — each is its own line, so the invoice reads like the quote. Pulling and hauling off a fence past saving is a separate line. See the full Kansas City staining detail →
REVIEWS
4.9 ★ · 85 Google reviews
Every review is on our Google Business Profile — read them there, unedited.
Read all 85 reviews on GoogleGARNETT FENCE QUESTIONS
The questions we field most often on Garnett jobs. Not here? Ring (913) 286-1091 and ask — the owner usually answers himself.
Free estimate, same-day response during business hours. Built for the wind, sealed against the weather — finish included in the plan.
Ready when you are
